Quick Summary: A working restaurant staffing guide plans the kitchen station by station, because a short-handed fry station fails differently from a short-handed sauté station. Keep the chef and sous chef as permanent hires, match each line cook to the skill the station demands, and treat prep, dish and porter coverage as the volume roles that keep everything else moving. The deciding question for every gap is whether it repeats: predictable gaps suit a temporary or temp-to-hire worker, while a permanent hole calls for a direct hire.
Friday at 6:30 PM is when a kitchen finds out whether its schedule was built on paper or on reality. A tickets rail that keeps growing usually points to one station, not the whole crew. This restaurant staffing guide is written for owners, chefs and kitchen managers who want to plan coverage around how a line actually works. If you are still settling the overall headcount, start with how many restaurant staff you need, then come back here to decide who belongs where.
General Workforce, a New York State MBE-certified staffing firm based in Ozone Park, Queens, has supplied food service and hospitality employers since 2005. The station-first approach below is the same one its recruiters use to match a cook to a kitchen.
Why a Staffing Guide for a Restaurant Starts at the Stations
Every station has its own pace, its own equipment and its own way of falling behind. Grill punishes bad timing. Sauté punishes slow hands. Fry punishes a lack of discipline around hot oil. A single headcount number hides all of that.
Planning by station also shows where one absence turns into three problems. When the prep cook calls out, the line starts service without full mise en place, the sauté cook cuts shallots during the rush, and the expeditor starts holding plates. The gap began at prep, but the guests feel it at the pass.
So the useful question is not “how many people do we need?” It is “which station breaks first on our busiest night, and who covers it?” Answering that one station at a time gives you a plan you can actually staff.
Kitchen Leadership: The Roles to Keep In-House
The executive chef or kitchen manager owns the menu, food costs, ordering, recipes and the standards every plate has to meet. The sous chef runs the line during service, writes the schedule and trains new cooks. These two roles carry your restaurant’s identity and its margins.
That is why leadership positions are almost always permanent, direct hires. A fill-in can cook a station well, but nobody should be learning your food cost targets during a Saturday dinner. If a leadership role opens up, a recruiter can still help you find candidates; the comparison of direct hire vs staffing agency lays out when each route makes sense. Treat these seats as long-term investments, and the rest of the plan has a foundation.
The Line, Station by Station
The line is where matching matters most. A strong cook on the wrong station can still slow the whole kitchen down.
Grill
The grill cook manages proteins cooked to temperature, often several tickets at different doneness levels at once. Look for someone who reads a thermometer without being told, keeps the grill clean between pushes and calls out timing to the expeditor. Steakhouses and burger concepts lean hardest on this station.
Sauté
Sauté is usually the most demanding seat on the line. Pans, sauces and pastas move fast, and the cook has to juggle several burners while plating. Put your most experienced line cook here, and back them up with someone who can step in on a slow night to learn the station.
Fry
The fry station rewards consistency: correct oil temperature, correct basket times, safe handling and filtering. It is a good station for a cook building experience, provided they have been trained on your fryers and your safety rules.
Cold Station or Garde Manger
Salads, cold appetizers, raw bar items and many desserts come off the cold station. Knife skills, portion control and a careful eye for plating matter more here than raw speed. A tidy cold station also protects food safety, since it handles the most ready-to-eat food.
Expeditor
The expeditor stands at the pass, reads tickets, calls fire times and checks every plate before it leaves. In smaller kitchens the sous chef or a server often takes this job. Either way, someone must own it on busy nights, or the stations drift out of sync and food dies under the heat lamp.
Prep, Dish and Porter Coverage
Prep cooks start before service and set up the line: cutting vegetables, portioning proteins, making stocks and sauces, labeling and dating everything that goes into the walk-in. A prep cook who is late or absent puts the whole line behind before the first ticket prints.
Dishwashers and porters keep pans, plates and floors moving. They are easy to overlook in a plan and painful to lose in the middle of a rush, when clean sauté pans run out and the line starts washing its own. These volume roles are also the easiest to cover with temporary staff, because the skills transfer quickly from one kitchen to the next with a short orientation.
Count these roles honestly in your plan. When prep and dish are covered, the cooks you pay most can stay on the work only they can do.
Restaurant Staffing Guide Template: Map Your Stations
A simple template turns this restaurant staffing guide into a working document. Build one table, or one page per shift, with these columns:
- Station: grill, sauté, fry, cold, pastry, expo, prep, dish, porter.
- Shift and hours: lunch, dinner, late night, brunch.
- Skill required: the specific tasks and equipment for that station on your menu.
- Primary person: who works it on a normal week.
- Backup: who can cover when that person is out.
- Gap type: one-off, seasonal or permanent.
Fill it in for your busiest week, not an average one. Any row with an empty backup column is a risk, and any row marked seasonal belongs in your hiring calendar. For the math behind cover counts and hours, the guide on how to calculate staffing needs walks through the numbers step by step.
Filling Station Gaps With a Staffing Partner
Once the template shows where the gaps are, decide how to fill each one. Patio season, holiday parties and festival weekends are predictable peaks, and the difference between temporary vs seasonal employees helps you pick the right arrangement for each.
General Workforce works as a strategic partner for restaurants and other food service employers. Every worker goes through its five-step hiring process, a background check and drug testing before placement, and the team matches candidates to the station you describe rather than sending a generic body. As employer of record, General Workforce handles payroll, taxes, workers’ compensation and insurance, and it gives your business full legal indemnification.
Two more details matter in kitchens. Transportation to and from the job is available, which helps when a closing shift ends after public transit slows down. The team also stays responsive after 5 PM and on weekends, so a Saturday call-out gets an answer while service is still on.
A temporary placement can also work like a paid internship. You watch how a prep cook handles your volume or how a line cook keeps up on a Friday, and you offer a permanent role only once you have seen the work. That trial turns a short-term fix into a long-term hire.
FAQs
What is a staff job description?
A staff job description is a written outline of one role: its duties, required skills, schedule, pay range and the person it reports to. List the equipment by name in each one, since “line cook” alone tells a candidate very little about the flat-top, salamander or slicer they will be working. Station-level descriptions also make it far easier for a staffing partner to send the right person on the first try.
Which kitchen roles can a staffing agency fill?
Prep cooks, line cooks, dishwashers and porters are the kitchen roles a staffing agency fills most often, and event cooks join that list during busy catering seasons. Head chef searches run differently, as a recruiting project with interviews rather than a same-week shift fill. Before the first shift, send your menu and a photo of the station setup, so the worker arrives already knowing the dishes and the layout.
How often should a kitchen update its staffing plan?
Update the plan whenever the menu, the hours or the cover counts change, and review it at least before each busy season. A new menu item can shift work from one station to another overnight. Set a reminder a month before your busiest stretch, so every backup is confirmed before the reservations fill up.
Is one station always the first to fall behind? Book kitchen coverage with General Workforce and staff every station before the next rush.




